MOCREO Sensor System
MOCREO Sensor SystemGuides

Deployment Guide

Contact Support

Choose a representative location, protect the Sensor body, and confirm the Sensor stays connected to the Hub after installation.

Where a Sensor sits decides whether its readings mean anything. Follow the common rules below, then open the guide for your environment.

Use a Probe Extension Cable

Use an extension cable with an external temperature-only probe that has a matching plug. Temperature and humidity sensors and probes cannot use these extension cables, even if the connector fits.

Specification3.5 mmUSB-C
Connector3-contact TRS, male to femaleUSB Type-C, male to female
Length per cable2 m (6.6 ft)2 m (6.6 ft)
  1. Match the cable to the probe plug. Use a 3.5 mm cable for a 3.5 mm plug or a USB-C cable for a USB-C plug.
  2. Insert the probe plug into the female end of the extension cable, then plug the male end into the port where the probe normally connects.
  3. For a temperature probe, connect up to three extension cables end to end for up to 6 m (19.7 ft) of added length. After installation, confirm the temperature reading updates in the app.

The 3.5 mm version of the SW2 water leak sensor worked with dozens of 3.5 mm extension cables connected in series during testing. After installation, wet the probe and confirm that the app reports a leak, then dry the probe.

Common Deployment Rules

Choose a Representative Location

  • Keep temperature Sensors away from direct sunlight, heaters, electronics, fans, air-conditioning outlets, and cooling vents.
  • Leave open space around the Sensor or probe so air can circulate.
  • Do not let a temperature probe touch food or a refrigerator wall directly.
  • Keep leak probes at the lowest likely collection point without putting the transmitter body in standing water.

Protect the Sensor Body

  • Keep non-waterproof Sensor bodies outside high-humidity and condensation-prone spaces whenever an external probe is available.
  • If a body must be placed inside, use appropriate moisture protection and food-grade desiccant.
  • IP67 protection helps against splashing and temporary submersion; it does not imply unlimited underwater use.

Preserve the Wireless Connection

  • Metal appliances, cabinets, machinery, and reinforced walls reduce wireless range. See Wireless Range.
  • Keep the Hub within range of every Sensor it serves; the ST7-CL and NM1 connect on their own and do not use a Hub.
  • Confirm the Sensor remains online after closing doors and completing installation.
  • Verify that the latest data timestamp continues to update before leaving the site.

Was this page helpful?

On this page