MOCREO Smart System
MOCREO Smart SystemGuidesH5 Hub

Configure H5 Display, Sound, and Sensor Views

Contact Support

Path: Home → Settings → Display & Sound

Display and Sound

Adjust brightness · Walkthrough

Watch this walkthrough or follow the steps below.

  1. On the APPS list, rotate the knob until Settings is in the middle, then press the knob.
  2. Rotate the knob to Display & Sound, then press the knob.
  3. Brightness is highlighted. Press the knob.
  4. Rotate the knob to choose a level. The screen, LED panel, and status light change as you rotate.
  5. Press the knob to save the level.
  6. Brightness shows the new level. To turn off only the status light, switch off Status Light.

Path: Home → Settings → Display & Sound

Available controls include:

  • Brightness — sets the screen, LED panel, and status light together. The level changes as you rotate and is saved when you press the knob.
  • Status Light — turns the status light on or off.
  • Sleep Mode — when turned on, From and To appear for the sleep hours. In Sleep Mode the screen and LED panel turn off.
  • Enable Buzzer — turn off to stop the buzzer from sounding for alarms. Turning it off also silences a buzzer that is already sounding.

If the H5 is currently inside the newly selected sleep period, it may ask whether to enter Sleep Mode immediately. Pressing the side button wakes the screen.

Sensor View

Choose how many sensors the screen shows · Walkthrough

Watch this walkthrough or follow the steps below.

  1. On the APPS list, rotate the knob until Settings is in the middle, then press the knob.
  2. Rotate the knob to Sensor, then press the knob.
  3. Rotate to Card View, then press the knob.
  4. Rotate the knob to Single, Double, or Quad, then press the knob.
  5. Card View shows your choice. Press the side button until you are back on the APPS list.
  6. Rotate until Sensor is in the middle, then press the knob.
  7. With Quad, the Sensor app shows four sensors at a time. Single shows one and Double shows two.

Path: Home → Settings → Sensor

Available controls include:

  • SensorView AutoSwitch
  • Card View: Single, Double, or Quad — how many sensors the Sensor app shows at a time
  • Sensor Data on LED Panel — shows a sensor reading on the LED dot matrix instead of the time
  • Name of the sensor selected for the LED panel

H5-Lite only

Directly Connected Probe is shown on H5-Lite. It is hidden on H5-Pro, which does not use the H5-Lite rear probe port.

When Sensor Data on LED Panel is enabled for the first time, select the sensor whose reading should appear on the dot-matrix display. For a temperature and humidity sensor, also choose Temperature or Humidity. Turn the switch off to show the time again.

LED Panel Time Format

Switch the LED panel between 12-hour and 24-hour time · Walkthrough

Watch this walkthrough or follow the steps below.

  1. On the APPS list, rotate the knob until Settings is in the middle, then press the knob.
  2. Rotate the knob to Locale, then press the knob.
  3. 24-Hour Time is off, so the LED panel shows 12-hour time with the PM indicator. Press the knob to turn it on.
  4. 24-Hour Time is on. The LED panel shows 14:30. Press the knob again to return to 12-hour time.

Path: Home → Settings → Locale

Turn on 24-Hour Time to show 24-hour time on the LED dot matrix. Turn it off for 12-hour time with the PM indicator. Times on the H5 screen, such as the Sleep Mode hours, follow the same setting.

Was this page helpful?

On this page