MOCREO Smart System
MOCREO Smart SystemGuidesH5 Hub

Maintain and Update an H5 Hub

Contact Support

Enter Setup Mode, find the Hub SN, check the version, update, reboot, or reset the H5.

Path: Home → Settings → My Devices

Setup and Software

Enter Setup Mode from Settings · Walkthrough

Watch this walkthrough or follow the steps below.

  1. On the APPS list, rotate the knob until Settings is in the middle, then press the knob.
  2. Rotate the knob to My Devices, then press the knob.
  3. Setup is the first item. Press the knob.
  4. The H5 enters Setup Mode. The status light breathes blue while setup starts.
  5. Follow Step 1: add the Hub in the MOCREO Smart App. The screen shows the Device Name and SN.
  6. To leave Setup Mode without changes, press the side button. A Hub that has never been added to an account cannot leave Setup Mode.
  • Setup — re-enters the onboarding flow for App or network setup. You can also choose Setup when the Device Unlinked prompt appears. In Setup Mode the status light breathes blue. A Hub that has never been added to an account cannot leave Setup Mode.
  • Version → Software Update — shows the installed version and update page.
  • Auto Upgrade — enables or disables automatic software upgrades.

Device Information

Find the Hub SN · Walkthrough

Watch this walkthrough or follow the steps below.

  1. On the APPS list, rotate the knob until Settings is in the middle, then press the knob.
  2. Rotate the knob to My Devices, then press the knob.
  3. Rotate the knob to SN. The Hub serial number is shown on the right.
  4. Keep rotating to see Account, Storage, Memory, and Uptime.

Rotate the knob to SN to find the Hub serial number. Keep rotating to see Account, Storage, Memory, and Uptime. For IP and MAC address, see network information.

Restart or Reset

  • Reboot restarts the H5 without intentionally clearing its saved configuration.
  • Factory Reset removes saved configuration and should only be used when you intend to set up the Hub again.

Use Setup for normal App addition or a network change. Do not use Factory Reset as a routine pairing step.

Was this page helpful?

On this page