Use the NS Sensor Button and Screen
The NS screen displays an action guide while the button is held. Release the button when the intended action is highlighted.
The NS screen displays an action guide while the button is held. Release the button when the intended action is highlighted.
| Button action | Result |
|---|---|
| Short press | Move to the next screen. If the display is asleep, the first press only wakes it. |
| Hold into the Sleep Screen range | Turn off the display; monitoring continues. |
| Hold into the Setup Wi-Fi range, about 5–10 seconds | Restart into Wi-Fi Setup. If already in Setup, exit that mode. |
| Hold into the Switch Theme range, about 10–15 seconds | Change the screen theme. |
| Hold into the Factory Reset range, 15 seconds or longer | Restore the device and require setup again. |
Watch the on-screen guide
Do not count seconds alone for long actions. The firmware shows the active action while you hold the button; release only when the desired action is displayed.
Page Sequence
- NS1: Home → Error Insights → Temperature History → System Info → Support
- NS2: Home → Error Insights → Temperature History → Humidity History → System Info → Support
- NS3: Home → Error Insights → Temperature/Humidity Probe History → Temperature Probe History → System Info → Support
On NS3, successive History pages cycle through temperature and humidity sources.
If an alarm is active on the Home screen, a short press dismisses the local alarm instead of changing pages.