Configure NS Alarms and Notifications

Path: Home → NS device card → Settings (⚙) → Alarm Settings

Tap the gear icon at the top right of the NS detail page to open Sensor Settings, then tap Alarm Settings. The page that opens is titled Alarm Rules.

Rules by Model

• NS1: temperature rules
• NS2: temperature and humidity rules
• NS3: rules are shown separately for each probe according to that probe's capabilities

Complete the Configuration

1. Enable the supported rule and set its acceptable range.
2. Set Anti-False Alarm or Active Hours when those controls are shown.
3. Enable Sensor Buzzer only when the selected hardware reports buzzer support.
4. Select App Push Notifications, Critical Alerts on supported iOS devices, or Email Notifications as required.
5. Tap Save.

For NS3, confirm the intended probe before editing. The App generates separate rule sections for multi-probe devices.

After saving, create one controlled out-of-range condition and verify both the local and remote behavior needed for the site.