H3 Release Notes

Release notes for MOCREO H3, covering firmware, app, portal, and device update history.

v1.2.1

H3 · 2026-09-01

Restored BLE advertising filtering so the Hub only processes advertisements from MOCREO Sensors, reducing scan load in environments with many Bluetooth devices. Note: scan response packets are filtered as well, so a Sensor name may appear incomplete or as its MAC address.
Added self-recovery for stalled BLE scanning: the Hub reboots itself if scanning stops reporting results for about 10 minutes, saving the Sensor list, history data, and logs beforehand.

Fixed connecting to the wrong access point when several access points share the same Wi-Fi name.
Fixed setup mode not exiting when re-entered without rebooting after provisioning.
Fixed Sensors reporting duplicate serial numbers for the same MAC address; the Hub now admits one of them and rebuilds the mapping on asset sync.

H3 · 2026-06-10

Added automatic default Sensor configuration when a Sensor is first added.
Sensor rules stored on the Sensor are now reset while the Sensor is being added, so a Sensor moved over from another Hub starts from a clean state.
BLE scanning is now stopped before the Hub enters setup mode, making setup more reliable in busy Bluetooth environments.

H3 · 2026-03-05

Added local hybrid mode.
Added the sync_network command, so the Hub can refresh and report its network information on request.

Adjusted the buzzer tone.
Added an exit condition when assets are fetched page by page, so a failed page no longer leaves the sync running.

H3 · 2025-11-12

Fixed CoAP notifications being mistaken for responses, which could leave a command without a reply.

H3 · 2025-09-14

Added remote alert dismissal, so an active alert can be dismissed from the App instead of at the Hub. The alert state is kept across a reboot, so a pending alert can still be dismissed after the Hub restarts.

H3 · 2025-07-26

Fixed MOCREO Sensors not being discovered after the first setup until the Hub was restarted.