MS1 App Addition and Deployment Guide
Put the MS1 into Setup mode, add it through an H1B or H2 Hub, then install and verify it.
Before You Start
- Power the MS1 and confirm that an H1B or H2 Hub is online.
- Enable Bluetooth on the phone and keep the phone, MS1, and Hub close together.
Add MS1 in the App
- Press and hold the MS1 Setup button for 3 seconds, then release it to enter Setup mode.
- In the MOCREO Sensor App, tap + and select MS1 Sensor.
- Select the online H1B or H2 Hub and follow the in-app instructions.
- Keep the MS1 close to the Hub until its card appears and reports a current temperature.
Install and Verify MS1
- Place the MS1 where air can circulate around it.
- Keep it away from excessive heat, moisture, dust, and large metal surfaces.
- Confirm a fresh temperature reading at the final location, then configure alerts.
For the complete product instructions, see the MS1 User Guide.