ST5 App Addition and Deployment Guide
Add the ST5 Bluetooth temperature sensor through an H1B or H2 Hub, then install its external probe.
Before You Start
- Charge the ST5 and confirm that an H1B or H2 Hub is online.
- Enable Bluetooth on the phone and keep the phone, ST5, and Hub close together.
Add ST5 in the App
- In the MOCREO Sensor App, tap + and select Temp Sensor - ST5.
- Select the online H1B or H2 Hub.
- Wait for the App to scan for nearby sensors, select the ST5, and complete the addition.
- Confirm that the ST5 card reports a current temperature before moving it.
Install and Verify ST5
- Secure the external probe at the measurement point and keep the ST5 body dry and accessible.
- Route the probe cable without sharp bends, tension, or pinching in a door seal.
- Confirm a fresh reading at the final location, then configure temperature alerts.
For the complete product instructions, see the ST5 User Guide.