ST10 App Addition and Deployment Guide
Add the ST10 Bluetooth ultra-low-temperature sensor through an H1B or H2 Hub, then install its external probe.
Before You Start
- Power the ST10 and confirm that an H1B or H2 Hub is online.
- Enable Bluetooth on the phone and keep the phone, ST10, and Hub close together.
Add ST10 in the App
- In the MOCREO Sensor App, tap + and select Temp Sensor - ST10.
- Select the online H1B or H2 Hub.
- Wait for the App to scan for nearby sensors, select the ST10, and complete the addition.
- Confirm that the ST10 card reports a current temperature before moving it.
Install and Verify ST10
- Secure the external probe at the ultra-low-temperature measurement point and keep the sensor body outside the cold space.
- Route the probe cable without sharp bends, tension, or pinching in a door seal.
- Allow the reading to stabilize, confirm an update at the final location, then configure temperature alerts.
For the complete product instructions, see the ST10 User Guide.