ST7-CL Local Controller Setup Guide
Add the ST7-CL directly to a nearby phone over Bluetooth, then configure and verify its temperature-controlled outlet.
Check the connected load
ST7-CL connects directly to the phone and does not use a Hub. Confirm that the controlled equipment stays within the electrical ratings in the product guide.
Add ST7-CL in the App
- Insert the external temperature probe firmly into the ST7-CL.
- Plug the ST7-CL into a powered outlet.
- In the MOCREO Sensor App, tap +, choose Socket, and select Temp Controller - ST7-CL.
- Hold the ST7-CL switch button for 5 seconds until its blue light flashes continuously.
- Select the discovered ST7-CL and complete the addition.
Install and Verify ST7-CL
- Secure the probe at the controlled temperature point and route its cable safely.
- Connect the load only after checking its electrical rating.
- Select the correct heating or cooling mode and configure the control thresholds.
- Verify the current outlet state and test manual switching before relying on automatic control.
For the complete product instructions, see the ST7-CL User Guide.