NM1 Local Controller Setup Guide
Connect the NM1 Router Rebooter directly to 2.4 GHz Wi-Fi and configure its local portal without a MOCREO Hub.
Direct Wi-Fi controller
NM1 connects directly to a 2.4 GHz Wi-Fi network. It does not use an H1B or H2 Hub.
Before You Start
- Confirm that the connected router or modem stays within the NM1 electrical rating.
- Prepare a 2.4 GHz Wi-Fi network and keep the phone near the NM1 and router.
Add NM1 in the App
- Power on the NM1 and confirm that its status light turns on.
- In the MOCREO Sensor App, tap + and select Router Rebooter - NM1.
- Hold the NM1 settings button for 5 seconds until the light turns blue.
- Select the 2.4 GHz Wi-Fi network and enter its password.
- Setup is complete when the App shows the device IP address and initialization information.
Install and Verify NM1
- Connect the network device to the NM1 outlet only after checking its electrical rating.
- Open the NM1 Portal from the device page and change the default portal password.
- Configure the monitoring and restart rules, then verify outlet control before relying on automatic recovery.
For the complete product instructions, see the NM1 User Guide.