ST4 App Addition and Deployment Guide
Bind the ST4 Zigbee temperature sensor to an H1B Hub, then install and verify it.
Zigbee binding
ST4 requires an online H1B Hub. It does not use the Bluetooth scanning flow used by ST5, ST6, ST9, ST10, SW2, MS1, or MS2.
Before You Start
- Add the H1B Hub and confirm that it is online.
- Keep the ST4 close to the H1B during binding.
- Prepare a paper clip or SIM tool for the sensor pinhole.
If the ST4 was supplied in a kit, its card may already appear in the App. Press the pinhole once and wait 5-10 seconds for an update before binding it again.
Bind ST4 to the H1B
- Press the ST4 pinhole once and check the status light.
- If the light blinks once and stops, hold the pinhole for about 6 seconds until the light flashes rapidly.
- In the MOCREO Sensor App, tap +, choose Sensor, select Temp Sensor - ST4, and select the online H1B.
- When the H1B beeps and opens its binding window, follow the App prompt while the ST4 light is flashing rapidly.
- Keep the ST4 beside the H1B until its card appears and reports a current reading.
Install and Verify ST4
- Secure the sensor or supplied probe at the intended temperature measurement point.
- Keep the sensor body dry and avoid crushing, bending, or pulling any probe cable.
- At the final location, press the pinhole once and confirm that the card updates within 5-10 seconds.
- Confirm the sensor remains online, then configure temperature alerts.
For the complete product instructions, see the ST4 User Guide.