MS2 App Addition and Deployment Guide
Put the MS2 into Setup mode, add it through an H1B or H2 Hub, then install its flat probe.
Before You Start
- Confirm that an H1B or H2 Hub is online.
- Enable Bluetooth on the phone and keep the phone, MS2, and Hub close together.
Add MS2 in the App
- Pull out the battery insulating tab to power the MS2.
- Press and hold the MS2 Setup/Test button for 3 seconds, then release it to enter Setup mode.
- In the MOCREO Sensor App, tap + and select MS2 Sensor.
- Select the online H1B or H2 Hub and follow the in-app instructions.
- Confirm that the MS2 card reports a current temperature before moving it.
Install and Verify MS2
- Use the magnetic mount to secure the MS2 body in a dry, accessible location.
- Position the flat probe at the measurement point and route its cable without crushing or tension.
- Confirm a fresh temperature reading at the final location, then configure alerts.
For the complete product instructions, see the MS2 User Guide.