SW2 App Addition and Deployment Guide
Add the SW2 Bluetooth water leak sensor through an H1B or H2 Hub, then place and test its detection probe.
Before You Start
- Charge the SW2 and confirm that an H1B or H2 Hub is online.
- Enable Bluetooth on the phone and keep the phone, SW2, and Hub close together.
Add SW2 in the App
- In the MOCREO Sensor App, tap + and select Water Leak Sensor - SW2.
- Select the online H1B or H2 Hub.
- Wait for the App to scan for nearby sensors, select the SW2, and complete the addition.
- Confirm that the SW2 card is online before moving it.
Install and Verify SW2
- Place the detection probe at the lowest likely leak point.
- Keep the SW2 body above the floor, dry, and accessible.
- Secure the cable so the probe cannot move away from the monitored area.
- Test the probe, confirm the App reports the state change, then restore it to a dry state.
For the complete product instructions, see the SW2 User Guide.