ST10 App Addition Guide
Keep the ST10, Hub, and phone close together during setup.
Before You Start
- ST10 sensor and supplied charging cable
- A compatible Smart System Hub already online in the App
- A phone with the MOCREO Smart App installed and Bluetooth enabled
Keep the ST10, Hub, and phone close together during setup.
Add ST10 in the MOCREO Smart App
-
Press the ST10 Setup pinhole for 1 second.
-
Open the MOCREO Smart App and confirm the Hub is online. A MOCREO account is not required for this addition.
-
On Home, tap + to open Add Devices, then select ST10 under Temperature & Humidity Sensor.
-
The App immediately starts Bluetooth discovery and binding. Keep it open until the addition finishes, then complete Setting up the room, Set name, and Monitoring Scene.
Complete the addition before the slow blue flash ends. A rapid blue flash indicates that the probe may be loose, making poor contact, or outside its supported range; check the probe before retrying.
Confirm the Device Was Added
Confirm that the ST10 appears in the App and reports a current temperature reading.
For body and probe placement, see the ST10 Deployment Guide.