ST5 App Addition Guide
Keep the ST5, Hub, and phone close together during setup.
Before You Start
- ST5 sensor and supplied charging cable
- A compatible Smart System Hub already online in the App
- A phone with the MOCREO Smart App installed and Bluetooth enabled
Keep the ST5, Hub, and phone close together during setup.
Add ST5 in the MOCREO Smart App
-
Press the ST5 Setup pinhole for 1 second.
-
Open the MOCREO Smart App and confirm the Hub is online. A MOCREO account is not required for this addition.
-
On Home, tap + to open Add Devices, then select ST5 under Temperature & Humidity Sensor.
-
The App immediately starts Bluetooth discovery and binding. Keep it open until the addition finishes, then complete Setting up the room, Set name, and Monitoring Scene.
Complete the addition before the blue status light stops flashing. If discovery times out, press the Setup pinhole for 1 second and try again.
Confirm the Device Was Added
Confirm that the ST5 appears in the App and reports a current temperature reading.
For body and probe placement, see the ST5 Deployment Guide.