SW3 App Addition Guide
Add the SW3 through Bluetooth discovery after the H6 Lite Hub is online.
Before You Start
- SW3 Sensor with two AAA batteries
- H6 Lite Hub already added to the MOCREO Smart App and online
- A signed-in MOCREO account
- A phone with the MOCREO Smart App installed and Bluetooth enabled
Add SW3 in the MOCREO Smart App
- If the batteries are not installed, remove the four screws from the bottom cover, install two AAA batteries, and secure the cover again.
- Power the H6 Lite Hub and confirm that it is online in the MOCREO Smart App.
- On Home, tap + to open Add Devices, then select SW3 under Water Leak Sensor.
- Keep the SW3 near the H6 Lite Hub and phone until Bluetooth discovery and binding finish.
- After binding, complete the in-app room and naming steps.
The SW3 uses Bluetooth LE with the H6 Lite Hub. A single press sends a data update after the Sensor has been added; it is not a separate setup-mode action.
Confirm the Device Was Added
Confirm that the SW3 appears in the App, shows as online, and reports a current update time.
For leak-detection placement, see the SW3 Deployment Guide.