ST6 App Addition Guide
Keep the ST6, Hub, and phone close together during setup.
Before You Start
- ST6 sensor and supplied charging cable
- A compatible Smart System Hub already online in the App
- A phone with the MOCREO Smart App installed and Bluetooth enabled
Keep the ST6, Hub, and phone close together during setup.
Add ST6 in the MOCREO Smart App
-
Press the ST6 Setup pinhole for 1 second.
-
Open the MOCREO Smart App and confirm the Hub is online. A MOCREO account is not required for this addition.
-
On Home, tap + to open Add Devices, then select ST6 under Temperature & Humidity Sensor.
-
The App immediately starts Bluetooth discovery and binding. Keep it open until the addition finishes, then complete Setting up the room, Set name, and Monitoring Scene.
Complete the addition before the blue status light stops flashing. If discovery times out, press the Setup pinhole for 1 second and try again.
Confirm the Device Was Added
Confirm that the ST6 appears in the App and reports current temperature and humidity data.
For mounting and environment guidance, see the ST6 Deployment Guide.